Saturday, January 18, 2014

Rear Drive shaft loop
Front Loop
A  Happy New  Year to all.Been working out in the shop with with a propane heater.Seems ok,stays around 55- 60.Cant't complain. I made this front drive shaft loop ,with some 1" tube for the loop and 1 1/4 for the lower brace and welded up to the center crossmember.It will sit about 4-6 inches from the u joint.
The rear loop I had bought several years ago from "welder series"
out of Canada.Paul Horton and son "DW" are good people and will work with you.
The rear one will be about 4"from the pinion snout when the 9" inch goes in.Centered everyhting and double checked before the welding was finished.

No comments:

Post a Comment